13
12
K
L
J
M
A
81
86
58
93
13. Set the console assembly (K) on the brackets on
the Handrails (86). Do not pinch any wires.
Attach the console assembly (K) with the four
5/16" x 3/4" Screws (4) that you removed in step
9 and four 5/16" Star Washers (11); do not fully
tighten the Screws yet.
Insert the excess Upright Wire (81) into the con-
sole assembly. Then, pull the two ties (L) tight
against the Upright Wire and cut off the ends of
the ties.
13
4
4
81
86
11
11
K
L
12. With the help of a second person, hold the con-
sole assembly (K) near the Handrails (86) (only
one side is shown).
Connect the ground wires (J) from the console
assembly (K) to the Console Ground Wires (58)
on the Crossbar (93).
Next, insert the Upright Wire (81) through the
two indicated looped ties (L) on the console
assembly (K).
Connect the Upright Wire (81) to the con-
sole wire (M). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again.
Then, remove the wire tie (A) from the Upright
Wire (81).
86
