24
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. To adjust the drive belt,
first
press the power switch to the off position and
unplug the power cord.
See EXPLODED DRAWING B on page 30. First,
remove the M4 x 16mm Screw (61) from the Left Leg
Inner Cover (39). Then, remove the Left Leg Inner
Cover and the Left Leg Outer Cover (92).
Next, remove the two M8 x 16mm Screws (76) and the
two M8 Washers (33) from the Left Upper Body Leg
(101) and the Left Pedal Arm (14).
Then, remove
the M8 x 14mm
Shoulder Screw
(81) from the Left
Pedal Arm (14).
Remove the Left
Pedal Arm from
the elliptical.
Remove the four M4 x 16mm Screws (not shown)
from the Large Storage Foot (27), and then remove
the Large Storage Foot. Remove the two M4 x 16mm
Screws (not shown) from the Top Shield (37), and then
use a flat screwdriver to pry the Top Shield upward off
the elliptical. Then, pry the left Pedal Disc (36) off the
elliptical.
See EXPLODED DRAWING C on page 31. Remove
all of the M4 x 16mm Screws (61) and M4 x 38mm
Screws (64) from the Left and Right Shields (44, 45).
Make sure to note which size Screws come from
which holes.
Then, carefully remove the Left Shield.
Loosen the Idler Screw (97). Tighten the Idler
Adjustment Screw (72) until the Drive Belt (46) is tight.
When the Drive Belt is tight, retighten the Idler Screw.
When you are finished, reattach the left shield, the left
pedal disc, the top shield, the large storage foot, and
the left pedal arm. Then, plug in the power cord.
46
72
97
37
14
81
36
27
Summary of Contents for NTEL99413.0
Page 4: ...4...
