13
10. With the help of a second person, hold the con-
sole assembly (D) near the Handrails (74).
See the inset drawing. Connect the Upright
Wire (83) to the console wire (F). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER.
Next, connect the two fan wires (B, G). Then,
remove any wire ties from the Upright Wire (83)
and the fan wires, and insert the excess fan wire
into the Upright (84).
83
84
D
F
10
9. IMPORTANT: To avoid damaging the Pulse
Crossbar (80), do not use power tools, and do
not overtighten the #10 x 3/4" Screws (6) or
the 5/16" x 2" Screws (2).
Orient the Pulse Crossbar (80) as shown. Attach
the Pulse Crossbar with two of the 5/16" x 2"
Screws (2) that you removed in step 3, two 5/16"
Star Washers (8), and two #10 x 3/4" Screws (6);
start all four Screws, and then tighten them.
Then, tighten the other two 5/16" x 2" Screws (2).
80
9
8
8
2
2
83
F
2
2
6
6
B
G
74
Summary of Contents for NTL14114.0
Page 5: ...5...
