16
15. Remove the 5/16" Nut (9) and the 5/16" x 2 1/4"
Bolt (4) from the bracket on the Frame (52).
Align the upper end of the Storage Latch (56)
with the bracket on the Frame (52), and insert a
5/16" x 2 1/4" Bolt (4) through the bracket and
the Storage Latch. This will push a spacer (I)
out of the Storage Latch; discard the spacer.
Next, tighten the 5/16" Nut (9) onto the 5/16" x
2 1/4" Bolt (4). Do not overtighten the Nut; the
Storage Latch (56) must be able to pivot.
Then, lower the Frame (52) (see HOW TO
LOWER THE TREADMILL FOR USE on page
33).
52
4
9
56
15
17. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 35 and 36). Note: Extra parts may be
included.
I
16
121
122
D
121
16. Attach the Tablet Holder (122) to the back of
the console assembly (D) with four 1/4" x 5/8"
Screws (121); start all four Screws, and then
tighten them. Do not overtighten the Screws.
Summary of Contents for NTL14114.0
Page 5: ...5...
