10
3.
Insert the fan wire (A) into the left Upright (84).
Next, slide the Left Base Cover (89) onto the
left Upright (84), and slide the Right Base Cover
(90) onto the right Upright.
Tip: You may need
to use a standard screwdriver to pull the Left
Base Cover away from the left Upright so that
the Left Base Cover will slide over the welded
plate (B).
Next, press the Base Covers down-
ward until they snap into place.
Next, slide the Upright Covers (141) onto the
Uprights (84) until they snap into place.
Then, remove and save the four 5/16" x 3"
Screws (88) and four 5/16" Star Washers (8).
89
B
84
141
141
90
3
88, 8
88, 8
A
4.
Identify the left Tray Bracket (76), which has an
attached tie (C).
IMPORTANT: To avoid damaging the Tray
Bracket (76), do not use power tools.
Attach the left Tray Bracket (76) to the left
Upright (84) with two #8 x 3/8" Machine
Screws (142) and two #8 Flat Washers (23).
IMPORTANT: See the inset drawing. Make
sure that the Tray Bracket is attached with
the Machine Screws through the indicated
holes.
Attach the right Tray Bracket (76) as
described above.
Note: There is not a tie on the
right Tray Bracket.
See the inset drawing.
Pull the end of the fan
wire (A) out of the left Upright (84).
76
84
C
76
142
142
23
23
84
4
142
C
76
23
A
84
Summary of Contents for NTL22115.0
Page 5: ...5...
