ICON Health & Fitness PFTL69620-INT.0, User Manual

24

MAINTENANCE

Regular maintenance is important for optimal per-
formance and to reduce wear. Inspect and properly 
tighten all parts each time the treadmill is used. 
Replace any worn parts immediately. Use only 
manufactuer-supplied parts.

Regularly clean the treadmill and keep the walking belt 
clean and dry. First, 

press the power switch into the 

off position and unplug the power cord. 

Wipe exte-

rior parts of the treadmill with a damp cloth and a small 
amount of mild soap. 

IMPORTANT: Do not spray 

liquids directly onto the treadmill. To avoid damage 
to the console, keep liquids away from the console.

Then, thoroughly dry the treadmill with a soft towel.

TROUBLESHOOTING

Most treadmill problems can be solved by follow-
ing the simple steps below. Find the symptom that 
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual. 

SYMPTOM: The power does not turn on

a.  

If an extension cord is needed, use only a 3-conduc-
tor, 14-gauge (2 mm

2

) cord that is no longer than 

5 ft. (1.5 m).

b.  

After the power cord has been plugged in, make 
sure that the key is inserted into the console.

c.  

Check the power switch located on the treadmill 
frame near the power cord. If the switch protrudes 
as shown (A), the switch has tripped. To reset the 
power switch, wait fi ve minutes, then press the 
switch back to the reset position (B).

SYMPTOM: The power turns off during use

a.  

Check the power switch (see drawing c at the left). 
If the switch has tripped, wait for fi ve minutes and 
then press the switch back in.

b.  

Make sure that the power cord is plugged in. If the 
power cord is plugged in, unplug it, wait for fi ve 
minutes, and then plug it back in.

c.  

Remove the key from the console, and then 
reinsert it.

d.  

If the treadmill still will not run, please see the front 
cover of this manual.

SYMPTOM: The console displays remain lit when 
you remove the key from the console

a.  

The console features a display demo mode, 
designed to be used if the treadmill is displayed in 
a store. If the displays remain lit when you remove 
the key, the demo mode is turned on. To turn off 
the demo mode, hold down the Stop button for a 
few seconds. If the displays are still lit, see THE 
SETTINGS MODE on pages 21 and 22 to turn off 
the demo mode.

SYMPTOM: The incline of the treadmill does not 
change correctly

a.  

See step 3 on page 21 to calibrate the incline.

B

A

c

MAINTENANCE AND TROUBLESHOOTING