11
12. Attach the Water Bottle Holder (37) to the
Upright (4) with two M4 x 16mm Screws (104).
37
4
104
104
13
13. While a second person holds the Console (7)
near the Upright (4), connect the console wire
to the Wire Harness (111). Then, connect the
console pulse wires to the Pulse Wires (63).
Insert the excess wire downward into the
Upright (4).
Tip: Avoid pinching the wires.
Attach the
Console (7) to the Upright (4) with four M4 x
16mm Screws (104).
See step 3.
Tighten the M8 x 19mm Patch
Screws (82).
7
63
111
104
4
Console Wire
Pulse
Wires
Avoid pinching
the wires
15. M
ake sure that all parts are properly tightened before you use the elliptical.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the elliptical to protect the floor.
14. Plug the Power Adapter (112) into the DC Jack
(not shown) on the front of the elliptical.
To plug the Power Adapter (112) into an outlet,
see HOW TO PLUG IN THE POWER
ADAPTER on page 12.
14
112
12
Summary of Contents for PRO-FORM 590 E
Page 22: ...22 NOTES...
