20
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap.
IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip pulse sensor, or if the displayed
heart rate appears to be too high or too low, see step
5 on page 16.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while
you are pedaling, even
while the resistance is
adjusted to the highest
level, the drive belt may
need to be adjusted. To
adjust the drive belt, first
use a flat screwdriver to
rotate the right Disc (71)
counterclockwise. Then,
remove the right Disc from the right Disc Mount (72).
Locate and loosen the M10 x 22mm Bolt (89). Next,
tighten the M8 x 38mm Hex Screw (88) until the Drive
Belt (113) is tight. Then, retighten the M10 x 22mm
Bolt.
Reattach the right disc by rotating it clockwise into the
right disc mount.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first use a flat screwdriver to rotate the left disc
counterclockwise. Then, remove the left disc from the
left disc mount.
Locate the Reed Switch (38). Loosen, but do not
remove, the indicated M4 x 16mm Reed Switch Screw
(69). Slide the Reed Switch slightly closer to or away
from a Magnet (43) on the Pulley (19). Then, retighten
the M4 x 16mm Screw. Turn the Pulley for a moment.
Repeat until the console displays correct feedback.
Reattach the left disc by rotating it clockwise into the
left disc mount.
HOW TO GREASE THE ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Rollers (51) squeak when moving on
the Ramp (3), apply a small amount of white marine
grease equally to each Roller. Spread the grease
evenly around the Rollers. Pedal the elliptical exercis-
er until a thin film of grease is distributed along the
Ramp; wipe off any excess grease.
MAINTENANCE AND TROUBLESHOOTING
89
72
71
113
43
38
69
88
19
