14
16
71
91
16
13
12
14
16. Identify the Left and Right Handlebars (12, 13).
Slide a Handlebar Sleeve (14) onto the Right
Handlebar (13). Then, insert the Right Handlebar
into the Right Handlebar Leg (16).
Attach the Right Handlebar (13) with two
M10 x 45mm Screws (71) and two M10
Washers (91).
Then, slide the Handlebar Sleeve (14) downward
onto the Right Handlebar Leg (16).
Repeat this step to attach the Left
Handlebar (12).
15
15. Apply a small amount of grease to a Leg
Axle (54).
While a second person holds the front end of the
Right Pedal Leg (18) inside the bracket on the
Right Handlebar Leg (16), insert the Leg Axle
(54) into both parts. Make sure that the Leg
Axle is fully inserted.
Next, finger tighten an M5 x 10mm Screw (100)
into the Leg Axle (54) and the Right Handlebar
Leg (16).
Then, tighten an M8 x 17mm Shoulder Screw
(73), a Leg Cap (55), and an M8 x 30mm
Washer (65) into the Leg Axle (54).
Fully tighten the M5 x 10mm Screw (100).
Repeat this step on the other side of the
trainer.
16
73
54
100 Grease
55
65
18