30
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belts may need to be adjusted. To adjust the drive
belts, first unplug the power adapter.
Next, remove the
four indicated
M4 x 16mm
Screws (93) and
the Center Shield
Cover (31).
Then, locate the two M6 Locknuts (80). Tighten the
Locknuts the same number of turns; this will tighten
the Right and Left Belts (67, 81).
Stand on the trainer and pedal for a few moments. If
the pedals still slip, repeat the actions described above.
When you have properly adjusted the drive belts,
reattach the center shield cover.
93
31
80
81
67
80