14
16
17
45
16. Center the Walking Belt (36) on the Walking
Platform (35).
IMPORTANT: Keep hands, clothing, and
other objects away from the Right and Left
Roller Brackets (47, 48) during this step.
Grasp the center (D) of the Idler Roller (50) and
the Walking Belt (36) firmly with both hands.
Rotate the Idler Roller downward until both
Roller Brackets lock into the Right and Left Rear
Feet (45, 46); pull the Roller Bracket Pins (49)
if needed to fully seat the Roller Brackets in the
Rear Feet.
Then, make sure that the Roller
Bracket Pins are fully engaged.
17.
See the inset drawing.
Turn the ring on the
right Roller Bracket Pin (49) to a vertical position
as shown.
Slide the Right Foot Cover (51) over the Right
Rear Foot (45) as shown.
Make sure that the
ring on the Roller Bracket Pin (49) goes
through the hole (E) in the Right Foot Cover.
Attach the Right Foot Cover with three M4.2 x
19mm Screws (3);
start all three Screws, and
then tighten them.
Attach the Left Foot Cover (not shown) as
described above.
47
49
49
48
50
46
35
3
51
3
45
36
D
49
49
E
18. Identify the Left and Right Foot Rail Pads
(31, 32).
IMPORTANT: Before you adhere the Foot
Rail Pads (31, 32), you must fi rst prepare the
surface of the Walking Platform (35).
Using
a towelette or cloth moistened with 70–90%
isopropyl alcohol (rubbing alcohol), clean the
surface of the Walking Platform on each side
of the Walking Belt (36).
Make sure that these
areas are free of oil, dirt, or any other debris.
Next, peel the paper backing (F) off the bottom
of the Left Foot Rail Pad (31). Carefully align
the edge of the Left Foot Rail Pad with the outer
edge of the Walking Platform (35), and press it
onto the Walking Platform in the location shown.
Attach the Right Foot Rail Pad (32) as
described above.
18
35
31
32
36
F
35
