32
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and
properly tighten all parts each time the elliptical is
used. Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the elliptical, use a damp cloth and a small
amount of mild soap.
IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in and that the power
switch is in the reset position.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings.
IMPORTANT: Doing
this will erase all custom settings you have made
to the console.
Resetting the console requires two
people. First, press the power switch into the off posi-
tion. Next, locate the small reset opening (A) on the
back or the side of the console. Using a bent paper
clip, press and hold the reset button inside the open-
ing, and have a second person press the power switch
into the on position. Continue holding the reset button
until the console turns on. When the reset operation
is complete, the console will turn off and then turn
back on. If it does not, press the power switch off and
then on again. Once the console turns on, check for
firmware updates (see HOW TO CHANGE CONSOLE
SETTINGS on page 30). Note: It may take a few
minutes for the console to be ready for use.
INCLINE SYSTEM TROUBLESHOOTING
If the ramp does not adjust to the selected incline level,
see HOW TO CHANGE CONSOLE SETTINGS on
page 30 and calibrate the incline system.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted. To adjust the drive belt,
first
press the power switch and unplug the power
cord.
Next, locate the
Access Cover
(3) on the Right
Shield (74).
Remove the
M4 x 16mm
Screw (101) and
then remove the
Access Cover.
Next, locate
and loosen the
Idler Screw (89).
Tighten the Drive
Belt Adjustment
Screw (91) until
the Drive Belt
(113) is tight.
Then, retighten
the Idler Screw.
Reattach the parts that you removed. Then, plug in the
power cord.
A
74
3
101
113
91
89
MAINTENANCE AND TROUBLESHOOTING
Summary of Contents for Pro-Form Carbon E10
Page 5: ...5 STANDARD SERVICE PLANS...
