13
10
7
10.
See step 5. Tighten the four M10 x 25mm
Screws (92).
Next, untie and discard the wire tie on the Main
Wire (110).
While a second person holds the Console (7)
near the Upright (4), connect the wires (C) on
the Console to the Main Wire (110) and to the
Pulse Wire (63) in the Upright.
Insert the excess wire into the Upright (4) or into
the Console (7).
Tip: Avoid pinching the wires.
Attach the
Console (7) to the Upright (4) with four
M4 x 16mm Screws (101);
start all the Screws,
and then tighten them.
101
4
110
63
C
101
Avoid pinching
the wires
92
92
11
11. Orient the Rear Console Cover (80) as shown,
and attach it to the Upright (4) with two
M4 x 16mm Screws (101).
Then, orient the Front Console Cover (79) as
shown, and attach it to the Rear Console Cover
(80) with two M4 x 16mm Screws (101).
79
4
80
101
101
101
Summary of Contents for Pro-Form Carbon E7
Page 5: ...5 STANDARD SERVICE PLANS...
