33
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first
press the power switch and unplug the
power cord.
Next, using
a standard
screwdriver,
carefully pry off
the left Disc (71).
Locate the Reed Switch (38). Turn the Pulley (19) until
a Magnet (43) is aligned with the Reed Switch.
Next, slightly loosen the indicated two #8 x 1/2" Flange
Screws (50). Slide the Reed Switch (38) slightly closer
to or away from the Magnet (43), and then retighten
the Flange Screws.
Then, plug in the power cord, press the power switch,
and rock the Pulley (19) forward and backward just
enough that the Magnet (43) passes the Reed Switch
(38) repeatedly. Repeat these actions until the console
displays correct feedback.
When the reed switch is correctly adjusted, reattach
the left disc and plug in the power cord.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted. To adjust the drive belt,
first
press the power switch and unplug the power
cord.
Next, locate the
Access Cover
(3) on the Right
Shield (74).
Remove the
M4 x 16mm
Screw (101) and
then remove the
Access Cover.
Next, locate
and loosen the
Idler Screw (89).
Tighten the Drive
Belt Adjustment
Screw (91) until
the Drive Belt
(113) is tight.
Then, retighten
the Idler Screw.
Reattach the parts that you removed. Then, plug in the
power cord.
71
19
43
50
38
74
3
101
113
91
89
Summary of Contents for Pro-Form Carbon E7
Page 5: ...5 STANDARD SERVICE PLANS...