21
HOW TO CONNECT YOUR HEART RATE MONITOR
TO THE CONSOLE
The console is compatible with all BLUETOOTH Smart
heart rate monitors.
To connect your BLUETOOTH Smart heart rate moni-
tor to the console, press the Bluetooth Smart button
on the console. When a connection is established, the
LED on the console will flash red twice.
Note: If there is more than one compatible heart rate
monitor near the console, the console will connect to
the heart rate monitor with the strongest signal.
To disconnect your heart rate monitor from the con-
sole, press and hold the Bluetooth Smart button on the
console for 5 seconds; the LED on the console will light
while the button is held and turn off when the button is
released.
Note: All BLUETOOTH connections between the
console and other devices (including any smart
devices, heart rate monitors, and so forth) will be
disconnected.
THE SETTINGS MODE
The console features a settings mode that allows you
to select a unit of measurement for the console and to
view console usage information.
To select the settings mode, press and hold down the
On/Reset button until the settings mode information
appears in the display.
The console can show pedal-
ing speed and distance in either
miles or kilometers. The upper
display will show the selected
unit of measurement. An E for
English miles or an M for metric
kilometers will appear in the display. To change the
unit of measurement, press the Watts Workouts button
repeatedly.
Note: When you replace the batteries, it may be
necessary to reselect the unit of measurement.
Press the Calorie Workouts but-
ton to view the total distance and
the total time. The center display
will show the total time (in hours)
that the console has been used
since the elliptical was pur-
chased. The lower display will
show the total distance (in miles or kilometers) that the
elliptical has been pedaled.
To exit the settings mode, press the On/Reset button
twice.
