25
HOW TO MAINTAIN THE EXERCISE BIKE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent.
IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO MAINTAIN THE PEDALS
Tighten the pedals weekly. Tighten the
right
pedal
clockwise
, and tighten the
left
pedal
counterclockwise
.
HOW TO TROUBLESHOOT THE CONSOLE
If the console display becomes dim, promptly replace
the batteries (see assembly 15 on page 14); most
console problems are the result of low batteries. Make
sure to clean the contacts on the batteries and the
contacts in the compartment each time you install
batteries.
If the exercise bike will not be used for an extended
period of time, remove the batteries from the console.
If the message CH0 or CH1 appears in the display
when you press the increase and decrease buttons,
you must recalibrate the resistance system. First,
see assembly step 15 on page 14 and remove
the batteries from the console. Next, press and hold
any button on the console for 20 seconds. Then,
release the button and reinsert the batteries into the
console; the exercise bike will adjust to the lowest
resistance level.
HOW TO TROUBLESHOOT THE TABLET HOLDER
If the tablet holder does
not stay in place, rotate
the tablet holder backward
and tighten the locknut (A)
inside the bracket mount
until the tablet holder stays
in place when it is rotated
to the desired position.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first locate the Reed Switch
(57) on the left side of the exercise bike. Slightly loosen
the two M4 x 20mm Screws (87).
Next, turn the Left Crank Arm (19) until a Magnet (62)
is aligned with the Reed Switch (57). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 20mm Screws (87).
Turn the Left Crank Arm (19) for a moment. Repeat
the procedure above, if necessary, until the console
displays correct feedback.
A
19
87
62 57
MAINTENANCE AND TROUBLESHOOTING
Summary of Contents for PRO-FORM Le Tour de France CBC
Page 4: ...4 STANDARD SERVICE PLANS...
