12
8
9
F
F
81
H
27
4
4
87
27
81
G
8.
With the help of a second person, hold the con-
sole assembly (F) near the Right Upright (90).
See the inset drawing.
Connect the Upright
Wire (81) to the wire (G) from the console
assembly (F).
The connectors should slide
together easily and snap into place.
If they
do not, turn one connector and try again.
IF
YOU DO NOT CONNECT THE CONNECTORS
PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE
POWER.
Next, set the console assembly (F) on the brack-
ets on the Right Handrail (87) and Left Handrail
(not shown);
do not pinch any wires.
Then, remove any wire ties (H) from the Upright
Wire (81).
9.
Attach the console assembly (F) with the four
1/4" x 1/2" Screws (4) that you removed in step
7 and four 1/4" Star Washers (27);
start all four
Screws, and then tighten them.
90
G
