12
13. Insert the pulse wires and the Upright Wire (not
shown) into the Handrails (92, 93) as you set the
console assembly on the Handrails.
Attach the console assembly with four 5/16" x
5/8" Screws (4) and four 5/16" Star Washers
(12). Start all four Screws, and then tighten
them.
Tighten the four 3/8" x 1" Screws (6).
13
12
4
12. With the help of a second person, hold the con-
sole assembly near the Uprights (90, 99).
Connect the Upright Wire (88) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Next, connect the two pulse wires. Then, remove
the wire tie from the Upright Wire (88).
Console
Assembly
Console
Wire
Console
Assembly
12
Pulse Wires
Pulse Bar
Assembly
99
90
88
93
92
6
6
12
4
Console
Wire
Wire
Tie
88
