15
33. Orient the Seat (70) with the wide end on the side
shown. Attach the Seat to the Bench Frame (63)
with four M6 x 16mm Bolts (80).
10
14. Wrap the Butterfly Cable (32) around a “V”-Pulley
(25). Attach the Pulley and a Large Cable Trap
(27) to the bracket on the Centre Upright (5) with
an M10 x 60mm Bolt (47) and an M10 Nylon
Locknut (49).
16. Wrap the Butterfly Cable (32) around a “V”-Pulley
(25). Attach the Pulley and a Large Cable Trap
(27) to the bracket on the Centre Upright (5) with
an M10 x 60mm Bolt (47) and an M10 Nylon
Locknut (49).
17. Attach the Butterfly Cable (32) to the bracket on
the Right Butterfly Arm (11) with an M8 x 22mm
Shoulder Bolt (60) and an M8 Nylon Locknut (48).
15. Remove the 90mm Pulleys (24) from the pre-
assembled Double “U”-Bracket (29).
Wrap the Butterfly Cable (32) under a 90mm
Pulley (24). Attach the Pulley to the Double “U”-
Bracket with an M10 x 45mm Bolt (57) and an
M10 Nylon Locknut (49).
14
49
Bracket
47
25
27
32
5
15
24
57
49
29
16
17
48
60
11
32
47
32
49
5
27
Bracket
Bracket
25
32
34. Press three 45mm Square Inner Caps (42) into
the Leg Lever (66).
Attach the Weight Tube (65) to the Leg Lever (66)
with an M8 x 58mm Bolt (41), two M8 Washers
(53), a 13mm x 10mm Spacer (75), and an M8
Nylon Locknut (48).
Press a 25mm Round Inner Cap (45) into the
indicated end of the Weight Tube (65). Press the
25mm Round Angle Cap (76) onto the other end
of the Weight Tube.
35. Lubricate the M10 x 68mm Bolt (46) with grease.
Attach the Leg Lever (66) to the Front Leg (64)
with the Bolt and M10 Nylon Locknut (49).
33
34
35
36
70
63
80
42
45
65
76
41
53
48
53
75
42
42
66
72
72
72
72
66
64
81
81
81
81
71
71
72
72
49
46
64
80
Wide
End
66
Lubricate
36. Press the six 19mm Round Inner Caps (81) into
the ends of the three Pad Tubes (71).
Slide a Pad Tube (71) into the hole in the Front
Leg (64). Slide two Foam Pads (72) onto the
ends of the Pad Tube.
Slide the other two Pad Tubes (71) into the holes
in the Leg Lever (66). Slide two Foam Pads (72)
onto each Pad Tube.
