Assigning Zones to Individual Channels
If you are using zones to send commands to more than one destination, each
zone must have its own channel. Otherwise, a command or note played on the
keyboard would send that “note-on” message everywhere, instead of to the
particular part of the module or software it is controlling. Be sure to set the
target for each zone to receive on that MIDI channel only, by turning off the
Omni mode Rx function on your targeted devices or modules.
ZONE 1
ZONE 2
ZONE 3
ZONE 4
GRP A
GRP B
GRP C
GRP D
RANGE
A
NULL
NRPN PANIC
GLOB
CHAN
B
MUTE
LAY
123456
DEV. ID
VEL.CURVE
TRANS
CC
CHAN
BANK LSB MSB
RECALL
ZONE
STORE
OCT
F P V
18
When Zone 1 is active, it has a default channel of 1,
Zone 2 defaults to Ch.2, etc. To change these
assignments, press the
Zone Chan (Ad Zone
Chan)
button. The LCD display will flash “Zone 1.” You
can select a zone channel other than 1 by turning the
jogwheel. The upper-case letters “CH” appear in the
LCD when you are setting MIDI zone channels. These
settings are NOT global channel, they only apply to
the MIDI zones you have selected to assign channels
for.
