11
7. Using a plastic bag to keep your fingers clean,
apply some of the included grease to the Long
Axle (35) and to two 16mm Wave Washers (54)
(only one is shown).
Insert the Long Axle (35) through the Upright (4)
and center it.
Slide a 16mm Wave Washer (54) and the Right
Upper Body Arm (61) onto the right side of the
Long Axle (35).
Repeat these actions for the Left Upper Body
Arm (47).
Tighten an M8 x 16mm Screw (82) and an M8
x 22mm Washer (97) into each end of the Long
Axle (35)
at the same time.
6. Identify the Right Upper Body Arm (61) and the
Right Upper Body Leg (60) and orient them as
shown.
Attach the Right Upper Body Arm (61) to the
Right Upper Body Leg (60) with three M8 x
43mm Bolts (96) and three M8 Jam Nuts (102).
Make sure that the Jam Nuts are in the indi-
cated hexagonal holes. Do not tighten the
Bolts yet.
Attach the Left Upper Body Arm (47) to the
Left Upper Body Leg (46) in the same way.
6
7
Hexagonal
Holes
60
61
96
102
47
47
46
61
82
82
97
35
4
54
Grease
Summary of Contents for NordicTrack AUDIOSTRIDER 990 PRO
Page 4: ...4...
