ICON NordicTrack COMMERCIAL X32i, User Manual

28

SYMPTOM: The walking belt slows when walked on

a.  

Use only a surge suppressor that meets all of the 
specifications described on page 13.

b.  

If the walking belt is overtightened, incline trainer 
performance may decrease and the walking belt 
may become damaged. First, remove the key and 

UNPLUG THE POWER CORD.

 Using the hex key, 

turn both idler roller screws (C) counterclockwise, 
1/4 of a turn. When the walking belt is properly 
tightened, you should be able to lift each edge 
of the walking belt 3 to 4 in. (8 to 10 cm) off the 
walking platform. Be careful to keep the walking 
belt centered. Then, plug in the power cord, insert 
the key, and walk on the incline trainer for a few 
minutes. Repeat until the walking belt is properly 
tightened. 

For a helpful video demonstration, 

scan the QR code with your smart device.

c.  

The incline trainer features a walking belt coated 
with high-performance lubricant. 

IMPORTANT: 

Never apply silicone spray or other substances 
to the walking belt or the walking platform 
unless instructed to do so by an authorized 
service representative. Such substances may 
deteriorate the walking belt and cause exces-
sive wear. 

If you suspect that the walking belt 

needs more lubricant, see the front cover of this 
manual.

d.  

If the walking belt still slows when walked on, see 
the front cover of this manual.

SYMPTOM: The walking belt is off-center or slips 
when walked on

a. 

 If the walking belt is off-center,

 first remove the 

key and 

UNPLUG THE POWER CORD.

If the 

walking belt has shifted to the left,

 use the hex 

key to turn the left idler roller screw clockwise 1/2 
of a turn; 

if the walking belt has shifted to the 

right,

 turn the left idler roller screw counterclock-

wise 1/2 of a turn. Be careful not to overtighten the 
walking belt.

Then, plug in the power cord, insert 

the key, and walk on the incline trainer for a few 
minutes. Repeat until the walking belt is centered. 

For a helpful video demonstration, scan the QR 
code with your smart device.

b. 

 If the walking belt slips when walked on,

 first 

remove the key and 

UNPLUG THE POWER 

CORD.

 Using the hex key, turn both idler roller 

screws clockwise, 1/4 of a turn. When the walk-
ing belt is correctly tightened, you should be able 
to lift each edge of the walking belt 3 to 4 in. (8 to 
10 cm) off the walking platform. Be careful to keep 
the walking belt centered. Then, plug in the power 
cord, insert the key, and walk on the incline trainer 
for a few minutes. Repeat until the walking belt 
is properly tightened. 

For a helpful video dem-

onstration, scan the QR code with your smart 
device.

3–4 in.

b

C

a

b