25
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. To adjust the drive belt,
first
press the power switch to the off position and
unplug the power cord.
Next, remove the indicated M4 x 16mm Screw (61),
the Left Leg Inner Cover (39), and the Left Leg Outer
Cover (92).
Then, remove the two M8 x 16mm Hex Screws (76)
and the two M8 Washers (33) from the Left Upper
Body Leg (101) and the Left Pedal Arm (14).
Remove the
M8 x 14mm
Shoulder Screw
(81) from the Left
Pedal Arm (14),
and remove the
Left Pedal Arm
from the elliptical.
Next, remove the four M4 x 16mm Screws (not shown)
from the Large Storage Foot (27), and remove the
Large Storage Foot. Remove the two M4 x 16mm
Screws (not shown) from the Top Shield (37), and
then use a standard screwdriver to pry the Top Shield
upward off the elliptical. Then, pry the left Pedal Disc
(36) off the elliptical.
See EXPLODED DRAWING C on page 31.
Identify
the Left and Right Shields (44, 45). Remove all of the
M4 x 16mm Screws (61) and 3/16" x 1 1/2" Screws
(64) from the Left and Right Shields.
Make sure to
note which size Screws come from which holes.
Then, carefully remove the Left Shield.
Next, loosen the Idler Screw (97). Tighten the Idler
Adjustment Screw (72) until the Drive Belt (46) is tight.
When the Drive Belt is tight, retighten the Idler Screw.
When you are finished, reattach all of the parts that
you removed. Then, plug in the power cord.
39
33
33
92
101
76
14
76
61
37
14
81
36
27
46
72
97
Summary of Contents for NTEL99413.1
Page 5: ...5...
