23
6. Measure your heart rate if desired.
You can measure your heart rate using either the
handgrip heart rate monitor or a compatible heart
rate monitor.
For information about purchasing
an optional chest heart rate monitor, see
page 27.
The console is compatible with all BLUETOOTH
®
Smart heart rate monitors. To connect your heart
rate monitor to the console, see page 25.
Note: If you use both heart rate monitors at the
same time, the BLUETOOTH Smart heart rate
monitor will have priority.
Before using the
handgrip heart
rate monitor, re-
move the sheets
of plastic from the
metal contacts.
In addition, make
sure that your
hands are clean.
To measure your heart rate,
stand on the foot
rails
and place your hands on the metal contacts—
avoid moving your hands.
When your pulse is
detected, your heart rate will be shown.
For the
most accurate heart rate reading, continue to
hold the contacts for about 15 seconds.
7.
When you are
fi
nished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button,
and
adjust the incline of the treadmill to zero.
The incline must be at zero when you fold the
treadmill to the storage position, or you may
damage the treadmill.
Next, remove the key from
the console and put it in a secure place.
When you are
fi
nished using the treadmill, press
the power switch into the off position and unplug
the power cord.
IMPORTANT: If you do not do
this, the treadmill’s electrical components may
wear prematurely.
HOW TO USE AN ONBOARD WORKOUT
1.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page 21.
2.
Select an onboard workout.
To select an onboard workout, press the Incline,
Calorie, Interval, Intensity, or Speed button repeat-
edly until the desired workout appears in the dis-
play.
A few seconds after you select a workout, the dura-
tion, distance, and maximum speed settings of the
workout will appear in the display for a few sec-
onds.
3. Start the walking belt.
Press the Start button.
A moment after you press
the button, the treadmill will automatically adjust to
the
fi
rst speed and incline settings for the workout.
Hold the handrails and begin walking.
Each workout is divided into several one-minute
segments. One speed setting and one incline set-
ting are programmed for each segment. Note: The
same speed and/or incline settings may be pro-
grammed for consecutive segments.
At the end of each segment, the speed and/or in-
cline setting for the next segment will
fl
ash in the
display to alert you if the setting is about to change.
The treadmill will then automatically adjust to the
speed and incline settings for the next segment.
The workout will continue in this way until the
last segment ends. The walking belt will then
slow to a stop.
If the speed or incline setting for the current seg-
ment is too high or too low, you can manually over-
ride the setting by pressing the Speed and Incline
buttons; however,
when the current segment of
the workout ends, the treadmill will automati-
cally adjust to the speed and incline settings
for the next segment.
Contacts
