15
16. Firmly tighten the four 3/8" x 2 3/8" Screws
(7), the two 3/8" x 1 3/4" Screws (62), and the
two 3/8" x 1 1/4" Screws (63). Make sure that
the Wheels (97) can turn freely.
Next, set the Left Inner Base Cover (106) onto
the lower end of the Left Upright (89). Slide the
Left Base Cover (82) downward and press it
onto the Left Inner Base Cover.
Then, set the Right Inner Base Cover (14) onto
the lower end of the Right Upright (90). Slide the
Right Base Cover (83) downward and press it
onto the the Right Inner Base Cover.
106
83
82
62
89
7
7
63
62
14
63
16
90
18. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 26 and 27). Note: Extra parts may be
included.
17
105
Start First
17. Press the two tabs on the Tablet Holder (105)
into the slots (L) in the console assembly (J).
Attach the Tablet Holder (105) with four #8 x 5/8"
Machine Screws (26). Note: Start the two top
Machine Screws first, and then start the two
bottom Machine Screws. Be careful not to
overtighten the Machine Screws.
IMPORTANT: The Tablet Holder (105) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
J
L
26
97
97
