ICON PRO-FORM POWER 795, User Manual

30

MAINTENANCE

Regularly clean the treadmill and keep the walking 

belt clean and dry. First, 

press the power switch into 

the off position and unplug the power cord.

 Wipe 

exterior parts of the treadmill with a damp cloth and a 

small amount of mild soap. 

IMPORTANT: Do not spray 

liquids directly onto the treadmill. To avoid damage 

to the console, keep liquids away from the console.

Then, thoroughly dry the treadmill with a soft towel.

TROUBLESHOOTING

Most treadmill problems can be solved by following 

the simple steps below. Find the symptom that 

applies, and follow the steps listed. If further assis-

tance is needed, see the front cover of this manual. 

SYMPTOM: The power does not turn on

a.   Make sure that the power cord is plugged into a 

surge suppressor, and that the surge suppressor 

is plugged into a properly grounded outlet (see 

page 20). Use only a surge suppressor that meets 

all of the specifications described on page 

20. 

IMPORTANT: The treadmill may not be compat-

ible with AFCI-equipped outlets.

b.  

After the power cord has been plugged in, make 

sure that the key is inserted into the console.

c.   Check the power switch located on the treadmill 

frame near the power cord. If the switch protrudes 

as shown, the switch has tripped. To reset the 

power switch, wait for five minutes and then press 

the switch back in.

SYMPTOM: The power turns off during use

a.   Check the power switch (see drawing c at the left). 

If the switch has tripped, wait for five minutes and 

then press the switch back in.

b.   Make sure that the power cord is plugged in. If the 

power cord is plugged in, unplug it, wait for five 

minutes, and then plug it back in.

c.   Remove the key from the console, and then  

reinsert it.

d.   If the treadmill still will not run, please see the front 

cover of this manual.

SYMPTOM: The console displays remain lit when 

you remove the key from the console

a.   The console features a display demo mode, 

designed to be used if the treadmill is displayed in 

a store. If the displays remain lit when you remove 

the key, the demo mode is turned on. To turn off 

the demo mode, hold down the Stop button for a 

few seconds. If the displays are still lit, see THE 

SETTINGS MODE on page 28 to turn off the demo 

mode.

SYMPTOM: The displays of the console do not 

function properly

a.  

Remove the key from the console and 

UNPLUG 

THE POWER CORD.

 Remove the five #8 x 3/4

" 

Tek Screws (14). Carefully pivot off the Motor Hood 

(65).

MAINTENANCE AND TROUBLESHOOTING

Reset

Tripped

c

65

14

14

a

14

14