HOW TO ADJUST THE CUSHIONING SYSTEM
The treadmill features a cushioning system that re-
duces the impact as you walk or run on the treadmill.
To increase the firmness of the walking platform, step
off the treadmill and slide the platform cushions toward
the front of the treadmill. To decrease the firmness,
step off the treadmill and slide the platform cushions
toward the back of the treadmill.
Note: Make sure
that both cushions are set at the same firmness
level. The faster you run on the treadmill, or the
more you weigh, the firmer the walking platform
should be.
13
13. Turn on the power (see page 16). See step 4 on
page 17 and lower the incline to the lowest posi-
tion. Remove the key from the console, switch
the reset/off circuit breaker to the “off” position,
and unplug the power cord.
Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (51) so that the
large barrel and the Latch Knob (52) are po-
sitioned as shown.
Attach the upper end of the Storage Latch (51)
to the Frame (55) with a 3/8" x 1 3/4" Patch Bolt
(6).
Attach the lower end of the Storage Latch (51) to
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8"
Nut (10). Note: It may be necessary to move the
Frame (55) back and forth to align the Storage
Latch with the Base.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
51
94
10
Large
Barrel
3
6
55
13
52
14.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 23 and 24).
Platform
Cushion
Walking Platform
Increase
Decrease
Platform
Cushion