Firmware Update
When updating firmware a warning screen will appear:
Take note of the instructions and click [
OK
] to proceed.
While updating, the unit will display rapidly flashing orange lights in the LED level bar while the
firmware updates. At this point it is critical that you perform the hokey pokey and congratulate yourself
on such a fine purchase during this time, with the knowledge that you are already better than your
friends and musical peers.
In the Auracle for X-Series main menu, the AUDIO4c icon will disappear for a short time. The
AUDIO4c icon will reappear again without the previous yellow hazard warning to indicate that the
firmware is now current.
Audio Hookup- connecting a Mac, PC, iOS, or Android device
Connect a Mac, PC, iOS, or Android device to an available USB Device port, using the supplied
USB-C cable, and USB-C to USB-A adapter if necessary.
Connect your powered monitors or power amp and speakers via ¼” TRS or TS cables to the
AUDIO4c Audio Outputs 1&2.
Open your DAW and select the AUDIO4c as the audio output device. Once the AUDIO4c is selected,
it may be necessary to route audio from the master bus of your DAW to outputs 1&2 of the AUDIO4c
at the master track level.
Check your powered speakers or power amp, as well as the output level on your DAW to ensure that
volume is at a safe listening level before playing back audio.
Play some test audio, preferably in a loop. You may not hear anything until you bring up the output
level. Follow the instructions in the next section to adjust audio levels.
AUDIO4c User Guide v2021-0002
Page 6
