Sound check - Adjusting the output level to audio outputs on the rear of the AUDIO4c
There are two ways to adjust the output level: directly on the front panel Interactive Display, or using
the Auracle for X-Series software’s Audio Mixer. For information on using Auracle for X-Series
software to mix audio levels, proceed to the
section of the
.
Using the front panel Interactive Display:
Signal Level Mode
:
Touch the region centered around [
Out
] on the bottom row of the Interactive
Display until the [
Out
] indicator turns green. A green [
Out
] LED as pictured above indicates that the
LED meters are in
Signal Level Mode
. In this mode the LED meters will display the level of audio
being sent to the outputs highlighted green in the top row of the Interactive Display. To select an
output or outputs for monitoring using the LED meter, touch the region of the output number(s) you
wish to monitor until it turns green.
In the diagram above, outputs 1 & 2 are selected for visual monitoring using the LED meters on the
right. Output 1 is slightly higher than output 2 as indicated by the differing levels in the left and right
LED meters.
Note that turning the rotary encoder while in Signal Level Mode has no effect.
Gain Set Mode
: Touch the region centered around [
Out
] on the bottom row of the Interactive Display
until the [
Out
] indicator turns red. A red [
Out
] LED indicates that the LED meters are in
Gain Set
Mode.
Select the analog output channel you wish to adjust by touching the regions centered around
the corresponding number of the channel you want to adjust in the upper row of the interactive
display. When the channel(s) you intend to adjust are highlighted in green, turn the rotary encoder
clockwise to increase gain level(s) of the selected output(s). Turn the rotary encoder
counter-clockwise to decrease leve(s) of the selected output(s).
AUDIO4c User Guide v2021-0002
Page 7
