For example, if you have a single USB MIDI controller plugged into the host port on the rear of the
AUDIO4c and wanted to route MIDI data ONLY to a computer plugged in to USB device port 2, scroll
down on the [Source] column to the section marked
, and select [HST1].
To route your MIDI controller in [
HST1
]
ONLY
to the [DIN] port on USB Device jack 2, un-select all
destinations except for [
Jack 2
] DIN in the second column marked [
Device Port to Computer/DAW
]
in the Destination field, as seen below:
Default MIDI routing from [HST1] to [Jack 2-DIN]; MIDI information FROM HST-1 is routed to [Jack 2]
on the [DIN] port.
Additional configuration in your DAW is required to complete the MIDI route between the controller
connected at [
HST 1
] and your computer connected at [
USB Device Jack 2
]. Consult the
documentation of your DAW to uncover the mystical magic of allocating MIDI ports of connected
interfaces.
You may also find it helpful to rename MIDI Source and/or Destination ports to something that makes
more sense for your personal use case. Renaming must occur at the device level, outside of the
Auracle for X-Series software. Navigate to
for a helpful tutorial on renaming MIDI ports on
iConnectivity X-Series devices.
Destination
The [
Destination
] field will be blank until a [
Source
] is selected, after which the [
Destination
] field
will populate with all ports available for routing.
NOTE ON DESTINATION PORT NAMES:
AUDIO4c User Guide v2021-0002
Page 21
