iConnectivity
iConnectMIDI™ Owner’s Manual
Revision 0.5
Page 15
Need help?
Email us at
support@iconnectivity.com
tel
+1 (403) 457-1122
fax
+1 (403) 775-4168
url
www.iConnectivity.com
Owner’s Manual
Cable and Power Supply
iConnectMIDI is supplied with an AC power adapter and a USB-to-30-pin connector cable. The
AC power adapter (the large end) plugs into a power receptacle and the barrel jack (the small
end) plugs into iConnectMIDI rear panel jack labelled DC. Included with iConnectMIDI are
additional blade adapters that allow for plugging into various power receptacles in other parts
of the world.
A specialized cable (included) is needed to connect an iOS device to iConnectMIDI. Its two
different connectors on either end are a mini-USB connector (for connecting to iConnectMIDI)
and a 30-pin connector (for connecting to an iOS device such as an iPhone, iPod touch, iPad).
The 30-pin connector is locking. Ensure that it clicks into place when pushed into the
corresponding port on the iOS device. When removing the cable, press the side release buttons
on the connector casing of the 30-pin connector before pulling out the cable from the iOS
device. Do not attempt to remove the cable from the iOS device by pulling on the wire; doing
so may permanently damage the cable.
The cable’s USB connector plugs into one of the mini-USB host receptacles on the front panel
of iConnectMIDI. Up to two iOS devices can be plugged into iConnectMIDI; a second
iConnectMIDI cable (sold separately) is needed for this purpose.
Connecting a computer to iConnectMIDI requires a standard USB host cable (mini-USB male to
USB-A male, sold separately) to connect between the computer USB-A receptacle and
iConnectMIDI USB host connector receptacle.
Recessed reset switch
