Mio X-Series User Guide
Page 15
•
Powering Off
: To power off the mioXL, press and hold the Power Button (for 4 to 5
seconds) until the OLED display and all LEDs are turned off, then immediately release
the Power Button.
•
Entering Bootloader Mode
: Bootloader Mode can only be manually entered from the
Power Off state. First verify that the mioX is powered off and then press and hold the
Power Button down (for 4 to 5 seconds) as the unit cycles the eight LEDs through green
then red colors. After all LEDs are off, immediately release the Power Button. Bootloader
Mode is then indicated by a blank display and alternately flashing green DIN-MIDI and
USB-MIDI LEDs.
Top Row Controls
The four top row LEDs of the Touch Panel illuminate whenever there is activity on each type of
I/O port:
•
USB-DAW
(USB MIDI between mioX and your computer)
•
RTP-MIDI
(RTP/Network MIDI)
•
DIN-MIDI
(MIDI on DIN Ports)
•
USB-MIDI
(MIDI on USB Host Ports)
When the mioX
transmits
data
to another device, the corresponding LED will light up
green
.
When the mioX
receives
data from another device, the corresponding LED will light up
red
.
For example: When mioX receives USB MIDI from a connected computer, the
USB-DAW
LED will light
red
. When mioX transmits MIDI data out any of the DIN-MIDI
ports, the
DIN-MIDI
LED will light
green
.
The top row LEDs are also touch-sensitive controls that select screens for monitoring MIDI
activity. Each type of port has a page that displays activity on all ports simultaneously. All MIDI
monitor pages appear and operate in a similar fashion; take DIN-MIDI for example:
The upper line of dots indicates activity on DIN In ports 1 through 8. The lower line of dots
indicates DIN Out ports 1 through 12. In this example, the two brighter dots indicate DIN-MIDI
activity present on IN 2 and OUT 3.
