32
If you selected the Arm Away mode, you have until the Exit Delay is over to exit the
premises.
Otherwise, the system is automatically armed in Arm Stay mode. There is still an Exit Delay
period for the other Arming modes as well, but they do not require that the door open and
close during the period.
If you open and shut an Entry/Exit door during the Exit Delay and then re-enter the
premise, the Exit delay restarts at 120 seconds for Arm Stay and Arm Night or 60 seconds
for Arm Away. It will only do this one time. If the wrong code is entered, the countdown
timer resets to 60 or 120 seconds.
If an Entry/Exit door is left open at the end of Exit Delay, the Entry Delay immediately starts
and, if the system is not disarmed, an alarm will sound.
Bypassing Zones
To arm the system, the TouchScreen requires that a sensor zone be turned off (bypassed), if it has any of
the following troubles:
Sensor Tamper Detected
Tamper Detected
Sensor Communication Failure
It is NOT necessary to bypass for any other troubles. Instead, you must acknowledge the trouble before
arming the system.
Note:
Fire/smoke and carbon monoxide sensors cannot be bypassed.
Cancelling the Arming Process
If you arm the system in Arm Away or Arm Stay mode, the Security Status header displays a countdown
of the number of seconds until the Exit Delay is over. You can choose to cancel the arming process.
To cancel the arming process:
1. Tap the Security Status header while it is displaying a countdown.
The Security app is displayed with a keypad and the Disarm System tab active. The view from the
camera(s), if any, is displayed.
TouchScreen User Guide
