iCool COMPACT Cool, Owner'S Manual

11

Owner’s manual for iCool Recovery Systems

FUNCTIONS OF THE TOUCH BUTTONS

SYSTEM SETTINGS

Temperature Settings

When  your  iCool  starts  up,  you  are  offered  3 

different ways to choose a water temperature 

setting. Whichever method you choose it eventually 

takes you to the main run screen. If you make no 

setting, the system will automatically insert 15°C.

(around 59ºF) In this case you can go directly to the 

start pump and start system.

If you want to use your previous setting from 
the last session, you can touch the use previous 
setting button and the last setting you used will be 
automatically inserted into the system. Previous 
settings may have been lost if you have removed 
the mains power.

If you want to use a different temperature to the 
built in presets the most common users make, 
you touch the make new settings button  and this 
will take you to the screen illustrated below, where 
you can use the up and down arrows to select 
the temperature you require. After you make your 
setting touch of the start button to go to the main 
screen where you can start both the pump and the 
cooling system and where all relevant temperature 
information is clearly displayed.

When your iCool starts up, the first screen you will see 

offers you a SYSTEM SETTINGS button, OPTIMUM 

SETTINGS  ARE  AUTOMATICALLY  SELECTED  so 

there’s usually no need to use this feature. The three 
settings you can change are the fan speed range, the 
temperature from degrees Centigrade to Fahrenheit 
and the sound level from the screen.

Main Cooling Fan Speed

This allows you to set the main cooling fan to either NORMAL or QUIET 

MODE. Generally you should always leave it in the NORMAL mode which 

is fully automatic and allows the system to control the fan speed to give 

the very best efficiency and fastest cooling.

Quiet Mode

If you are in a very quiet environment you can select QUIET MODE, but 

you must be aware that this will reduce the cooling ability of the system, 

however it will be quieter overall as the fan will not run higher than 60% of 

maximum unless there is a risk of overheating, in which case the safety 

system will turn the fan back to high no matter what the setting. The 

NORMAL setting is used to give absolute maximum cooling power where 

higher fan noise is not a problem. On a normal day this gives about 25% 

more cooling than in the QUIET MODE.

Temperature Display Scale

This can be set to either Centigrade or Fahrenheit and this changes all of 

the displays throughout the entire system. When you first start the iCool 

it will normally start in Centigrade as this is the world standard. 

Note: Due to complex decimal calculations between Cº and Fº there 
may be minor difference in the true Fº displays. This has no effect on 
actual cooling accuracy. 

The sound level adjusts the sounds made by touching the screen and by 
the alarms. Normally it should be left on high to assist with settings and 
to make sure alarms are heard. 

A red dot indicates which setting is selected in each of the available 
settings.

SYSTEM SETTINGS

MAIN SCREEN

USE PREVIOUS SETTING

MAKE NEW SETTINGS

Touch Buttons Screen

Water Temperature Setting Screen

27

°

10

°