16
iCool Lite
engineered ways to ensure that no matter what happens in the field, in most cases you can still use your iCool for that important event. Realistically,
even the best electronic systems occasionally have problems, especially in portable systems that have a relatively hard life and where water and
heat are involved. Fortunately, we have very few such problems, but as an added benefit we have built into all iCool’s a complete manual override
system that allows your iCool to operate effectively even if the touch screen is damaged.
We do not publish this over ride information in the manual because it is a little different from model to model, but in the rare event that you ever
have a failure of the touch screen which prevents you from operating your iCool, just call or e-mail the local iCool representative in your country, or
our international number or go to our web site and we will give you instructions on how to use the manual over ride facility on your particular model.
At www.iCoolSport.com you will find a listing of representatives around the world, or you can request a reply directly from our factory in Australia.
You will be contacted promptly and we will explain how to work around your problem until we can arrange repairs. This is an important service that
we hope you never need, but it’s good to know it is there. In addition to this service you will be pleased to know that your iCool is of a modern modular
design, which means that most components can be easily replaced in the field and often by the owner.
UNDERSTANDING THE HEATING MODE PROTECTION CIRCUIT
For safety reasons you can only initiate the heating mode at the time the unit is first switched on. You can not change to heating while you are using
it in the cooling mode. You must switch off at the main switch first.
With TWIN models both heat pumps can cool at the same time or one can heat and one can cool at the same time.
You must use a pool cover when heating the water.
We all understand heat rises and so you must use a cover on top of your pool when heating or you will lose a large amount of the heat energy into
the room and it will take much longer to heat the water.
If the status bar lights turn red when you start a cooling cycle.
It means you have inadvertently selected a temperature that is higher than the current pool water temperature. Switch off at the main power switch
to reset the computers and start again, this time set a temperature that is LOWER than the current pool temperature. Once the iCool is operating in
the cooling mode you can then change your selected temperature to any temperature, even one that is higher than the current water temperature
and is will still stay in the cooling mode. This is useful if the early morning pool temperature is already lower than you require but you want the iCool
to prevent the water rising above your desired temperature as the day warms up.
Summary of Contents for COMPACT Cool
Page 1: ...Owners Manual iCool Lite ...
Page 2: ......
