06
iCool Compact
STEP 3
STEP 4
Connect the special I.E.C plug from the pump to
the marked socket on the side of the iCool
Connect Main Power Cable
Connect the main power cable provided with your iCool to a standard
power outlet capable of providing at least 12 amps in countries with a
220 V supply and 24 amps in countries with a 110 V supply. Although
the system requires much less power than this in normal operation, all
heat pump compressor motors need considerably more power for a
minute or so each time they starts up.
Your System Software will begin loading
Your iCool has a full colour high-resolution touchscreen that eliminates
all switches and provides complete control over your iCool system in a
user-friendly and intuitive manner.
It also provides a substantial amount of additional information to assist
you. When you turn on the power for the first time the system will load
the latest software from its memory card and run a diagnostic self test
routine. This will take about 20 seconds. During this time you will see
this screen (shown at right) and then a BLACK screen.
The System Status Bars will flash white
The STATUS BARS on each side at the front of the iCool will change colour
or flash to give a clear indication of each function. While the software is
loading the status bars will flash white, the screen shown at right will be
seen , then a black screen appears for about 15 seconds while computers
tests the safety systems.
The Main Power Switch
The Main Power Switch is also part of the ELECTRICAL SAFETY CIRCUIT that guards against the possibility of electric shock. Every electric
component in the iCool is protected by this device. It is a good idea to test this system each time you use the iCool by turning on the main switch
and then pressing the test button above the switch. If the safety system is working normally, pressing the test button will cause the main power
switch to shut down instantly.
After a SUCCESSFUL test, reset the main switch to ON to begin normal operation. If this test fails you must have your iCool checked by an
electrician before using it. It may not be safe.
WARNING
For safety, the power outlet you use must be earthed correctly. Your
pump must connect to the iCool not to an external power socket
WARNING
Always use this power socket, it provides electric safety
protection to the pump and your pool users.
The Software Loading Screen
