07
Owner’s manual for iCool Recovery Systems
STEP 5
Touch the start pump button. This will start the pump operating and
water should begin circulating.
NOTE! When you touch START buttons they change to STOP buttons
and can then be used to STOP that function if required.
It is essential that the water is flowing correctly before you TOUCH the
start SYSTEM button. The water flow is pre set to an optimum flow of
about 15-20 litres or around 3-5 gallons per minute. This allows time
for the heat exchanger to operate at maximum cooling efficiency. Pool
water is completely changed approximately every 15 to 20 minutes.Do
not touch the START SYSTEM button until you are sure that water is
flowing smoothly. If water does not flow smoothly within a minute or
so, please check that the hose with the pump is flat on the floor and no
part of it is higher than the top of the water. Check that the water in the
pool is higher than the pump. If this does not correct the problem the
system will sound an alarm and a red warning screen will appear with
information about how to correct the water flow problem.
Main Operating Screen
Personal Logo Screens
Water Temperature Setting Screen
After the self test is completed, your personal logo screen or a
WELCOME screen will appear. Touching this screen anywhere will stop
the bars flashing and show a steady white light to indicate that the
systems check was successful and that your iCool is ready to use.
The Status bars glow BLUE when only the pump is running, GREEN
when the cooling system is running and RED when the heating system
is running.
If the bars glow RED when you start cooling please refer to page 8 for
an explanation of the heat mode functions.
If you ordered a personal logo screen your WELCOME screen will
look like the samples (right). Otherwise the standard iCool welcome
screen will appear. touch YOUR logo OR WELCOME screen anywhere
to continue.
The Main Operating Screen will now appear
The main operating screen provides many options which are covered
elsewhere in this manual, however to quickly start the system you
can simply accept the default water temperature setting of 15ºC or,
to select a different temperature touch the CHANGE settings button.
Then 10ºC will be inserted automatically, but you can change to any
temperature you require at this point. Simply touch the up and down
arrow buttons and the desired pool water temperature will appear on
the bottom left-hand of the screen in the blue window marked “selected
temperature”. The right-hand side of the screen shows the outside air
temperature.
The temperatures is in degrees centigrade, however it can also be
displayed in Fahrenheit. This is explained later in this Manual.
Once you have selected the pool water temperature you want your iCool
to cool to, touch the start button. This takes you back to the main run
screen which is the screen that you will use most of the time during
normal operation.
15
°
24
°
10
°
22
°
30
°
22
°
