PPC-150P-EHL
User’s Manual
IUMPPC150PEHL-01 Ver.1.0A Aug, 2023
10
1.5.2 Panel Mounting
PPC-150P-EHL series support clamp mount that is an optional for ordering. Please
contact your region sales for ordering.
Ordering part number:
PANEL-MT-PPC-APL-SET
1. Please refer the Section 1.4 to make a cutout hole on your mechanical or frame.
Please note that there is thickness limitation of the mounting wall for
clamp mount installation. The suggestion of mounting wall thickness
limitation is 20 mm.
2. PANEL-MT-PPC-APL-SET includes 6pcs of clamp and screw, and each clamp
and screw is paired. Screws 6pcs of clamp and screw together respectively.
3. Place PPC in a cutout mechanical or frame, which mounts the panel to align the
bottom of the panel housing with the bottom edge of the cutout. This way can
help hold the panel steadily.
4. At the back side of the mounting wall, insert the clamp into the slide hole at the
side bracket on the panel. Fit the screw on the clamp and screw on both of
clamp and mounting wall. Please be careful and make sure that 6 clamps and
screws have been lock tightly.
