8
PDX3-090T DM&P Vortex86DX3 Panel PC with 9” WSVGA TFT LCD
1.5 Panel Mounting Instruction
1.
Cut a mounting hole in the panel. (Refer to PDX3-090T Dimensions
on page 7) (Note 1)
2.
Check and remove the twelve M3 screws in a diagonal pattern as
image below if necessary.
3.
Place PDX3-090T face-down on a clean, flat surface.
4.
Slide the panel cutout around the back of PDX3-090T, until the panel
rests directly on the gasket. Make sure the screw holes align with the
screw holes on PDX3-090T.
5.
The screw size is M3*L (L=wall thi 6.0mm) (Note 2)
6.
Insert all twelve M3 screws into the screw holes. (Note 2)
7.
Finger-tighten the M3 screws. Finish tightening the M3 screws in a
diagonal pattern using an M3 screw driver (see the image as below);
maximum torque 1.18Nm (12 kgf-cm).
