8
Icotera A/S, Vibeholms Allé 16, 2605 Brøndby, Denmark - info@icotera.com
Document version: 1.0
User Guide for 1.17.3 Firmware
Bottom bar
In the centre of the bottom bar, there are three buttons:
•
Reset
: resets all changes made in the current session.
•
Save
: saves all changes made in the current session.
•
Apply
: applies all changes saved during the current session.
Viewing status information
The
Status
menu provides tools for listing connected devices, viewing general CPE system information, as well as
to obtain information about WAN, LAN and wireless interfaces operating on the device. It also allows to view phone
info, VoIP call log, as well as information about WDS status and associated clients.
Connected devices
The
Connected devices
item of the
Status
menu contains information about devices connected to the CPE.
Figure 7.
Connected devices
item of the
Status
menu
The drop down lists allows to chose a particular interface and the table contains the following information:
•
IP address
: IP address of the connected device,
•
MAC address
: physical address of the connected device.
•
Hostname
: name of the connected device.
•
DHCP
:
Static
or
DHCP
(if the IP address was assigned by a DHCP server).
The data presented in the table can be refreshed at any time by clicking the
Refresh
button.
As this menu does not include any configurable options the
Reset
,
Save
, and
Apply
buttons are disabled.
General system information
To access general information about the CPE go to the
Status/System information
menu item.
The
System information
section contains general information about CPE state:
•
Current time
: current time and date,
•
Uptime
: duration the device has been powered up,
•
Firmware version
: current software version operating on the device,
•
WAN MAC
: physical address of the device’s WAN interface,
•
WAN IP
: IP address of device’s WAN interface,
•
Configuration mode
:
Unconfigured
(no steering or configuration propagation between CPE and i3550) or
Master
(steering and configuration propagation active between CPE and i3550).
•
Device name
: name of the device,
•
Serial number
: unit’s serial number,
•
Wi-Fi 802.11b/g/n
: The status of the Wi-Fi 802.11b/g/n wireless interface, either
On
or
Off
,
•
Wi-Fi 802.11ac
: The status of the Wi-Fi 802.11ac wireless interface, either
On
or
Off
.
