CL-200 Series User Manual Version 1.2.0 Apr. 2019
- 53 -
Wi-Fi Settings
The column of Current shows the current Wi-Fi settings. You can change the settings
by changing the column of New. The following table provides an overview of the
parameters contained in the Wi-Fi Settings section:
Item
Description
Mode
This parameter is used to specify the Wi-Fi mode of the CL-200-WF device.
It can be station or AP. For AP mode, only one device can be connected.
Wireless Security
This parameter is used to specify which security protocol is used to secure
wireless computer network. It can be open, WEP, or WPA/WPA2. It is
recommended to use WPA/WPA2 if possible.
DHCP Server (AP
Mode)
This parameter is used to specify whether to turn on the DHCP server
function. It is only available to the AP mode.
Wi-Fi Channel (AP
Mode)
This parameter is used to specify which channel is used for Wi-Fi
transmission. It can be 1 to 11. It is only available to the AP mode.
IP Address Type
(Station Mode)
This parameter is only available to the station mode and it can be Static IP
or DHCP. If DHCP is supported by the AP you would like to connect, then
DHCP should be selected. Otherwise, select Static IP and the following
three parameters IP Address, Subnet Mask and Gateway should be set, too.
