Copyright © 2019 ICP DAS Co., Ltd. All Rights Reserved.
P2
1
Introduction to the Configuration Parameters
1) Pan ID
：
group identity for a ZigBee network, and must the same for all devices
in the same ZigBee network. (Setting Range : 0x0000~0x3FFF)
2) Address/Node ID
：
distinguish identity of a specific the ZigBee module, and must be
unique for each device connected the same ZigBee network.
(Setting Range : 0x01~0xFF)
3) RF Channel
：
indicates the radio frequency channel, and must be set to the same
value as other modules on the same ZigBee network.
Channel
0x00
0x01
……
0x0F
Frequency(MHz)
2405
2410
……
2480
RF channels 0x04, 0x09, 0x0E or 0x0F are recommended because they
do not overlap with the Wi-Fi frequencies based.
2
Preparation
1) Before you use this Utility, please make sure you have installed the
Microsoft .NET
Framework 4. If you haven’t installed .NET Framework
yet, please refer to item 2 for more information, or refer to item 3 for
more information about the installation of this Utility.
2) To download .NET Framework, refer to: http://www.microsoft.com/en-
us/download/details.aspx?id=17851
3) The Utility software is located on the web at:
4) Connect DL-100TMS-ZT.
i.
Use ZT-2000 Coordinator connect Default Parameter
：
Protocol
Modbus
CheckSum
Enable
PAN ID
0x0001
Node ID
0x01
RF Channel 0x00
RF Power
0x07
ii.
Use RS-232
5) Power supply range
：
+10 ~ +30 VDC
