Firmware Update via Ethernet (Ver. 1.0/Sep. 2015)
Page:
9
Step 11: Confirm that the two MAC addresses (factory-default) listed in the Command Prompt
window,
“Waiting request from MAC x.x.x.x”
and
“BOOTPREQ from MAC: x.x.x.x”
,
are the
same, as indicated in the image below. If these addresses do not match, the update cannot
proceed. Refer to
below for more details.
Step 12: Once the update is complete (i.e., when the progess indicator reaches 100%), close
the Command Prompt window.
Note: If the Remote Firmware Update option fails, then the On-site Firmware Update (traditional)
option will need to be carried out in order to ensure the module is operational again.
Step 13: In the eSearch Utility, search for the ET-2200 module again to verify that it is
functioning correctly. Note that the network settings for the module may need to be
reconfigured after updating the firmware. Refer to Step 3 in Section 1 above for more
details.
Step 14: Click the name
of the ET-2200 module to
highlight it.
Step 15: Click the
“Web”
button and the default
web browser will be
opened.
Firmware update begins
Request received from this MAC Address
Waiting for a request from this MAC Address
13
14
15