GRP-530M / GRP-540M User Manual
Version 1.2.1
Page
：
79
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved E-mail: service@icpdas.com
4.8 Email or FTP report I/O logger file.
This example shows how to using GRP device to report I/O logger file periodically.
(1) About Modbus configure, please refer section 4.5.
(2) Configure Email / FTP
function in “Email/FTP” Tab. You must set “Data Log Interval”
field more than 0, or log report function will be disabled. (include FTP and Email)
⚫
Configure “Data Log Interval” to record IO data into csv file. (0
→
disable)
filename format: GRP-530_StationID_YYYYMMDD_hhmmss.csv
ex: GRP-530_13_20140806_172347.csv
⚫
Configure “Max. Time per Log File” to indicate how long to change / send back log
file. If the file size is close 3MB, GRP device will create a new log file to recode I/O
data and move old log fil
e into “/RTU/LOGFILE/” in SD card.
⚫
If you need FTP report function, please set all FTP parameters and set “Enable
FTP Function” as “Enable”. GRP device will send log file to FTP Sever when new
log file is available.
⚫
If you need Email report function, ple
ase set all Email parameters and set “Enable
FTP Function” as “Enable”. If you need 2 or more contact, please use comma “,”
to separate each contact.
