GW-7828 (Modbus RTU Slave to MBus Master Gateway) User Manual
Version 1.00
Page
:
11
Copyright © 2020 ICP DAS Co., Ltd. All Rights Reserved E-mail: service@icpdas.com
2.3 DIP Switch
The DIP switch is used to update firmware and configure M-Bus Meter setting. The functions of
each mode will be explained in detail in later chapters. After changing the configuration of the
DIP switch, the GW-7828 needs to reboot to enable the new setting.
Init Pin
Mode Pin
Description
OFF
OFF
Operation Mode
OFF
ON
Configure Mode
ON
OFF
Firmware Update Mode
ON
ON
Reserved