HRT-310 Modbus RTU to HART Gateway
- QuickStart (Aug/2017)
ICP DAS USA, Inc.
| 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717
3
P
e
t
t
h
e
d
i
P
l
e
a
s
e
s
e
t
t
h
e
d
i
p
D
I
DIP Switch Setting
Please set the dip switch of the “Resistor” and “Default” to be ”ON”
position.
Item
ON
Resistor
Enable HART loop resistor
(250 Ohm, 1W)
Default
Adapt the default settings.
(Refer to HART network wiring)
LED Indicator
LED
Status
Description
Name
PWR
ON
Module Power OK.
OFF
Module Power Failed.
ERR
Flash
HART Comm. Error.
OFF
HART Comm. OK
[ Flash per second ]
Module in initial mode.
Flash
[ Flash per half second ]
RUN
Module received the burst frame from
HART device.
ON
Module in normal operation.
OFF
Firmware has not been loaded yet.
