4.2. Setting up the I-2533CS series
After installing the utility tool, please follow the following steps to set up the
communication between the Utility and the I-2533CS series. Here is the example for the
I-2533CS configuration.
Step 1: Power off the I-2533CS.
Step 2: Set the rotary switch to ‘F’ and connect the PC available COM port with the
COM port of the I-2533CS. Users can find the communication cable (CA-0910)
in the product box. When connecting to the COM port of I-2533CS, the TXD pin
of the cable is connected to the TXD pin of the I-2533CS COM port, RXD pin of
the cable is connected to the RXD pin of the I-2533CS COM port, and GND pin
of the cable is connected to the GND pin of the I-2533CS COM port.
Figure 4-1 Wire connection of the RS-232
Step 3: Power on the I-2533CS. Then, the CAN_Err, CAN_Tx, CAN_Rx, FB_Err LEDs
will take turns to flash per 500 milliseconds.
I-2533CS series CAN to Single Mode Fiber Bridge User Manual (version 1.0.0)
Page: 24
Copyright © 2013 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
Step 4: Execute the I-2533CS Utility tool.
ГК
Атлант
Инжиниринг
–
официальный
представитель
в
РФ
и
СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
