M-7026
M-7026 User Manual Rev: 1.5 Date: 2016/03/10
54
2.15 $AA5VV
Description:
This command is used to specify the Analog Input channels to be enabled on a
specified module.
Syntax:
$AA5VV[CHKSUM](CR)
$
Delimiter character
AA
The address of the module to be set in
hexadecimal format (00 to FF)
5
The command to set the Analog Input channel(s) to enabled
VV
A two-digit hexadecimal value representing the Analog Input channel,
where bit 0 corresponds to channel 0, and bit 1 corresponds to
channel 1, etc. When the bit is 0, it denotes that the channel is to be
disabled and 1 denotes that the channel is to be enabled.
Response:
Valid Command:
!AA[CHKSUM](CR)
Invalid Command:
?AA[CHKSUM](CR)
!
Delimiter character to indicate a valid command
?
Delimiter character to indicate an invalid command.
AA
The address of the responding module in hexadecimal format (00 to
FF)
There will be no response if the command syntax is incorrect, there is a
communication error, or there is no module with the specified address.
Examples:
Command: $0150A
Response: !01
Enables Analog Input channels 1 and 3 on module 01 and disables all
other Analog Input channels. The module returns a response indicating
that the command was successful.
Command: $016
Response: !010A
Reads the status of the Analog input channels on module 01 and returns
a response indicating that the command was successful, with a value of
0A, which denotes that Analog Input channels 1 and 3 are enabled and all
other Analog Input channels are disabled.
Related Commands:
Section 2.16 $AA6
Summary of Contents for M-7026
