8. Software and Demo Program
The software drivers can be classified as follows:
z
for DOS: huge and large mode library for TC, MSC and BC
z
for Windows: DLLs for VC++, BC++, VB, Delphi, BCB, LabVIEW
There are about 20 demo program given as follows:
z
demo1: one board, D/I/O test, D/A test, A/D polling test, general test
z
demo2: two board, same as demo1
z
demo3: one board, A/D by software trigger(polling) and A/D by pacer trigger demo
z
demo4: two board, same as demo3
z
demo5: one board, M_function_1 demo
z
demo6: two board, same as demo5
z
demo7: one board, M_function_2 demo
z
demo8: two board, same as demo7
z
demo9: one board, M_function_3 demo
z
demo10: two board, same as demo9
z
demo11: one board, MagicScan demo
z
demo12: two board, same as demo11
z
demo13: one board, continuous capture demo
z
demo14: two board, continuous capture demo
z
demo15: all installed board, D/I/O test for board number identification
z
demo16: one board, performance evaluation demo
z
demo17: one board, MagicScan demo, scan sequence: 1
Æ
2
Æ
0
z
demo18: one board, MagicScan demo, scan 32 channel, show channel 0/1/15/16/17
z
demo19: one board, A/D calibration.
z
demo20: two board, P180X_FUNA, continuous capture demo
z
demo21: single board, P180X_FUNB, continuous capture demo
z
demo22: single board, P180X_FUNB, 330 k, 2.5 min, continuous capture 99 M bytes
z
demo23: single board, post-trigger demo
z
demo24: single board, pre-trigger demo
z
demo25: single board, middle-trigger demo
z
demo26: single board, pre-trigger demo for version-C
z
demo27: single board, middle-trigger demo for version-C
PCI-1202/1602/1800/1802 Hardware User’s Manual
(
Ver.4.2, Dec/2009, PMH-014-42)---- 96
