PDS Series User Manual ( V1.4, Oct. 2009) ----- 83
Network (TCP/IP) Setup page
IP Address
Subnet Mask
Gateway
The above three items are the most important network settings and should always
correspond to the LAN definition. If they do not match, the PDS series module will not
operate correctly. If the settings are changed while the module is operating, any links to
Virtual COM Port based applications currently in use will be lost and an error will occur.
DHCP Client : 0 = disabled, 1 = enabled
It is recommended that the DHCP Client setting is kept as disabled, and using static
network settings. This ensures your PDS always using a fixed IP address, and you don’t
need to configure the virtual COM mappings again and again.
UDP Search: 0 = disabled, 1 = always enabled.
2 = enable the UDP Search function until another client is connected. (Default = 2)
By keeping the UDP search setting as 2, the PDS loading will be reduced. The
VxComm Utility will not be able to search for this module until this module’s clients are
all disconnected.
Command Port
The default Command Port is 10000.
Web Server
Telnet Server
0 = disabled, 1 = enabled
Ping Gateway at start: 0 = disabled, 1 = enabled.
If the setting is 1 (enabled), the PDS series module will send a ping packet to the
gateway during the power-on stage. It is used to inform the gateway that a PDS (itself) has
joined the network.
TCP ACK Delay (ms), default = 50.
PDS does not want to send an empty ACK followed by a TCP data packet 1ms later,
every time. So it delays a little (TCP ACK Delay), and then can combine the ACK and
data packet into one. This efficiency reduces the number of packets and reduces network
loadings.
Summary of Contents for PDS-700 Series
